98mm Pre-Roll Cone Filling Machine Cartridge | Fills 55 Cones:
Pre-roll cone filling cartridges are a practical and efficient solution for filling empty pre-roll cones during preparation and packaging. Available in multiple sizes, these cartridges are designed to accommodate a wide range of cone formats and can be used with finely ground botanical material.
They are commonly used by brands, processors, and small-batch operators seeking speed, consistency, and reduced material loss during cone filling.
+ Speed & Efficiency
Filling cones individually by hand can be slow and labor-intensive. A pre-roll cone filling cartridge allows operators to fill multiple cones at the same time, significantly improving efficiency and reducing overall preparation time.
+ Consistent Fill Levels
Cone filling cartridges help ensure uniform fill height and density across each cone. This consistency supports predictable results and a more standardized finished product, especially important for multi-unit packaging.
+ Reduced Material Waste
By controlling how material is distributed into each cone, filling cartridges help minimize spillage and overfilling. This allows operators to use material more efficiently and maintain a cleaner workspace.
+ Compact & Portable Design
These cartridges are small, lightweight, and easy to transport, making them suitable for use in a variety of work environments, including temporary stations or mobile setups.
+ Simple, Low-Setup Operation
Pre-roll cone filling cartridges are designed for straightforward use with minimal setup. Simply load cones, add material, and begin filling—no complex adjustments required.
+ How to Use the Filling Machine Cartridge
-
Set the riser aside.
-
Insert empty cones into the cartridge openings.
-
Add ground material to the top of the cartridge.
-
Use the included tamping tool during operation to assist with even distribution.
Note: Firm tamping early in the process helps create consistent density near the crutch. -
Stop filling slightly below the top to allow room for finishing.
-
Place the riser underneath the cartridge.
-
Set the cartridge on top of the riser to raise the cones for easy access.
-
Remove each cone and finish as required for packaging.
+ Cleaning & Maintenance
-
Clean with warm water up to 130°F
-
Do not use a dishwasher, as excessive heat may cause warping
-
For residue removal, use an isopropyl alcohol and salt mixture
-
Avoid exposure to temperatures above 130°F
-
Do not leave outdoors or in direct sunlight for extended periods